The app is available on the Google Play Store. It will soon be available on the Apple App Store. Simply search for the WiNET+ app and install it on your device.

There are essentially three connection methods for the WiNET device:QR Code, the user must point the phone's camera or use the WiNET+ app to scan the QR Code on the device's label; Recommended choice.Manual Connection, by manually entering the codes located on the WiNET device label, as requested by the screen on your smartphone.Optional: WPS, if you enable the router's connection system, in fact, as soon as the device is powered on, it searches for the Wi-Fi network for a pre-set time, then switches to other connection modes.

WPS, if you enable the router's connection system, in fact, as soon as the device is powered on, it searches for the Wi-Fi network for a pre-set time, then switches to other manual connection modes.

Make sure the green LED is OFF, meaning you're definitely connected to the cloud and your home network. Check whether the Wi-Fi app icon is a red X or not.

From the WiNET+ App, by clicking on the icon with the Wifi symbol, I can access all the information relating to the connection status.

Check if the green LED is off.Check if your device is present in the Cloud with the green access buttonConnect to the Wifi module page and you must go to the “Status” page, and check the cloud connection.

Router turned off, check and turn it on if necessary.That the module is too far from the router, therefore the signal is too low.The password entered is incorrect, check the "Last disconnection error" item on the status page.The password has been changed on the router; Reconfigure the WiNET device for a new connection.Changed home router, then reconfigure system.

This information can be found on the Wi-Fi device's label. (The device must be available or installed in plain sight.)

It is listed on the label under WPA or Wifi WPA.

No, it's not necessary. The module allows point-to-point connections or triangulation through the router to which it's connected.

By clicking on the On/Off button at the top left of the App's main screen.

Using the dedicated buttons in the 'Room Temperature' section

Using the dedicated buttons in the 'Power' section.

You cannot control the stove remotely if it is in alarm mode. You must be in front of the stove to resolve the issue and restore it to working order.

It is only possible by calling the temperature, raising the temperature setpoint, and only after restarting the stove will it be possible to turn it off from the app.

From the main screen of the App.

When I open the app, it detects all the devices on this network. I just have to select which device to access. If there's only one, it will automatically be connected.

By activating the chronothermostat, with the appropriate button.

Yes. I can easily do that, because my home network still works, but I can't go out and access the cloud.